It is very easy to follow and it is aimed at beginners and proficient users alike. This goes for general Linux issues as well. I checked the support from the Kernel wiki and I suspect that your device may not be supported.Īgain, I suggest following the Arch wiki - Wireless network configuration, which provides a fantastic way to solve your issue. If the kernel module was loaded properly, you can proceed to the next step in the Arch wiki (#Utilities). If there is no erroneous output to the command in step 6, use dmesg | grep (in the case of step 6, it was iwlwifi.Check the kernel messages if the firmware is being loaded with dmesg | grep firmware, which should yield something like this:.If you get an error message, please provide it by commenting the answer I'm providing you. Use the ip link set up command to bring up your interface (e.g.TP Link C2300 AC2300 Wireless MU-MIMO Gigabit Router + RE450 AC1750 WiFi. If the adapter has been created the name of the adapter should start with a 'w' (e.g. Settings window Configure the wireless network adapter to use the Maximum. Check if the wireless interface has been created using ip link.Since the adapter is an USB adapter, you run dmesg | grep usbcore as root, which should give you an output similar to this usbcore: registered new interface driver rtl8188.Run lsusb -v, which should give you an output similar to this:Ġ6:00.0 Network controller: Realtek Semiconductor Corp.Better strap in, because it's going to be a long one:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |